Skateboarding Medal Hanger

Park series and jams, most of them on the same summer

Skate contests bunch up. A regional series runs four rounds between May and September and then goes quiet, so a skater collects everything they are going to collect inside one season and then waits.

That is an argument for buying one size up rather than exactly. This medal hanger is cut from a single sheet of stainless steel, and the 60 and 75 cm versions use 3 mm rather than 2.5 mm because a wider rail carries more weight across its span.

Skate medals are frequently non-standard — cut acrylic, wooden tokens, oversized discs. A continuous rail takes odd shapes that a hook rack cannot, because nothing has to line up with anything.

This medal holder comes in the widths listed here. For a gift, err wide — nobody has ever complained about too much room.

Size & capacity

Not sure which size?

Contest series bunch into one summer. Buy for three summers, not one.

The steel, and why it matters

Every medal display in the range is AISI 304 — the same grade used for kitchen surfaces and marine fittings — at 2.5-3 mm depending on width. It doesn't rust, doesn't chip, and doesn't need looking after.

The bar is continuous. That's the whole difference from a hook rack: hooks give you a fixed count, a rail gives you a length.

Fitting it to the wall

Comes with stainless standoffs, fixings and a paper drilling template. On plasterboard use proper anchors rather than the plugs supplied — a full display is heavier than it looks.

When it fills up

A second unit mounts flush against the first, so the wall still reads as one piece rather than two things hung near each other. The widest version holds up to 110 medals across three rails.

Delivery

Every medal display is cut and finished in our own workshop and dispatched within 3–5 working days. Returns accepted for fourteen days.