Runner Mom Medal Hanger V2

Buy it before the medals are unpacked, not after

The usual sequence is wrong. A family waits until there is a visible pile, by which time the medals have spent three years in a drawer and half of them are tangled. Hanging them is then a job rather than a moment.

Given early, this becomes the place they go on the evening of each race. The second of the two Runner Mom cuts, with a different figure to the first — pick whichever looks more like her.

Where the display goes matters for the choice between the two cuts. This one holds up better in a kitchen or a hallway, where it is seen in passing rather than studied.

This medal holder comes in the widths listed here. For a gift, err wide — nobody has ever complained about too much room.

Size & capacity

Not sure which size?

Same four widths as the first version, same capacities. The decision is aesthetic.

The steel, and why it matters

Every medal display in the range is AISI 304 — the same grade used for kitchen surfaces and marine fittings — at 2.5-3 mm depending on width. It doesn't rust, doesn't chip, and doesn't need looking after.

The bar is continuous. That's the whole difference from a hook rack: hooks give you a fixed count, a rail gives you a length.

Fitting it to the wall

Comes with stainless standoffs, fixings and a paper drilling template. On plasterboard use proper anchors rather than the plugs supplied — a full display is heavier than it looks.

When it fills up

A second unit mounts flush against the first, so the wall still reads as one piece rather than two things hung near each other. The widest version holds up to 110 medals across three rails.

Delivery

Every medal display is cut and finished in our own workshop and dispatched within 3–5 working days. Returns accepted for fourteen days.